Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
inductive_probe [2017/06/23 14:23]
sschueller
inductive_probe [2017/06/23 14:25] (current)
sschueller
Line 11: Line 11:
 ===== Software ===== ===== Software =====
  
-  - Modify Marlin to use the probe. See my version here: https://​git.techdroid.com/​sschueller/​marlin **(Notice: I have the eeprom enabled, you will need to clear it for you changes in the firmware ​to load)** +  - Modify Marlin to use the probe. See my version here: https://​git.techdroid.com/​sschueller/​marlin **(Notice: I have the eeprom enabled, you will need to clear it for your changes in the firmware ​take affect, ''​M502''​ followed by ''​M500''​)** 
   - Test the probe works with ''​M119''​ to see the z-min end stop status, you should see it change if you trigger the probe. Depending on if you have a NPN or PNP probe you may need to reverse the z-min endstop in the marlin configuration. ​   - Test the probe works with ''​M119''​ to see the z-min end stop status, you should see it change if you trigger the probe. Depending on if you have a NPN or PNP probe you may need to reverse the z-min endstop in the marlin configuration. ​