Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
anycubic_kossel_plus [2017/05/22 11:05] sschueller [Finding probe to hotend offset (Marlin)] |
anycubic_kossel_plus [2017/06/23 12:31] sschueller |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Anycubic Kossel Plus ====== | ====== Anycubic Kossel Plus ====== | ||
+ | |||
+ | [[BL Touch]] | ||
+ | [[Inductive Probe]] | ||
===== BL / 3D Touch Setup ===== | ===== BL / 3D Touch Setup ===== | ||
Line 52: | Line 55: | ||
- make a mark on the bed with a pen or sticker | - make a mark on the bed with a pen or sticker | ||
- Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10mm, Y -10mm and Z +10mm) | - Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10mm, Y -10mm and Z +10mm) | ||
- | - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' et.c until you reach the paper | + | - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' etc. until you reach the paper |
- Reset all values to Zero: ''G92 X0 Y0 Z0'' | - Reset all values to Zero: ''G92 X0 Y0 Z0'' | ||
- Move the hotend off the mark ''G1Z10'' | - Move the hotend off the mark ''G1Z10'' |