Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
anycubic_kossel_plus [2017/05/22 11:04] sschueller |
anycubic_kossel_plus [2017/05/22 11:05] sschueller [Finding probe to hotend offset (Marlin)] |
||
|---|---|---|---|
| Line 51: | Line 51: | ||
| ==== Finding probe to hotend offset (Marlin) ==== | ==== Finding probe to hotend offset (Marlin) ==== | ||
| - make a mark on the bed with a pen or sticker | - make a mark on the bed with a pen or sticker | ||
| - | - Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10, Y -10 and Z +10) | + | - Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10mm, Y -10mm and Z +10mm) |
| - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' et.c until you reach the paper | - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' et.c until you reach the paper | ||
| - Reset all values to Zero: ''G92 X0 Y0 Z0'' | - Reset all values to Zero: ''G92 X0 Y0 Z0'' | ||