Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
anycubic_kossel_plus [2017/05/22 11:03] sschueller |
anycubic_kossel_plus [2017/05/22 11:04] sschueller |
||
|---|---|---|---|
| Line 66: | Line 66: | ||
| - Zero Z, using ''G28'' | - Zero Z, using ''G28'' | ||
| - Level Bed ''G29'' (use ''G29 V4'' to see more log info) | - Level Bed ''G29'' (use ''G29 V4'' to see more log info) | ||
| + | |||
| + | ==== Update Slicer ==== | ||
| + | - In your slicer make sure you set the printer to do a ''G28'' then a ''G29'' before each print. | ||
| NOTICE: Doing a ''G28'' resets the autolevel values! I am still trying to figure out how to get Octoprint to not reset my auto level values before printing. | NOTICE: Doing a ''G28'' resets the autolevel values! I am still trying to figure out how to get Octoprint to not reset my auto level values before printing. | ||