Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
anycubic_kossel_plus [2017/05/14 16:09] sschueller |
anycubic_kossel_plus [2017/06/23 12:31] sschueller |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Anycubic Kossel Plus ====== | ====== Anycubic Kossel Plus ====== | ||
+ | |||
+ | [[BL Touch]] | ||
+ | [[Inductive Probe]] | ||
===== BL / 3D Touch Setup ===== | ===== BL / 3D Touch Setup ===== | ||
Line 51: | Line 54: | ||
==== Finding probe to hotend offset (Marlin) ==== | ==== Finding probe to hotend offset (Marlin) ==== | ||
- make a mark on the bed with a pen or sticker | - make a mark on the bed with a pen or sticker | ||
- | - Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10, Y -10 and Z +10) | + | - Move the hotend to this exact location (use G codes, e.g. ''G1X10Y-10Z10'' moves the probe to X +10mm, Y -10mm and Z +10mm) |
- | - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' et.c until you reach the paper | + | - Put a paper under the probe and move it until the paper sticks a bit. Use ''G1Z5'', ''G1Z4'' etc. until you reach the paper |
- Reset all values to Zero: ''G92 X0 Y0 Z0'' | - Reset all values to Zero: ''G92 X0 Y0 Z0'' | ||
- Move the hotend off the mark ''G1Z10'' | - Move the hotend off the mark ''G1Z10'' | ||
Line 66: | Line 69: | ||
- Zero Z, using ''G28'' | - Zero Z, using ''G28'' | ||
- Level Bed ''G29'' (use ''G29 V4'' to see more log info) | - Level Bed ''G29'' (use ''G29 V4'' to see more log info) | ||
+ | |||
+ | ==== Update Slicer ==== | ||
+ | - In your slicer make sure you set the printer to do a ''G28'' then a ''G29'' before each print. | ||
NOTICE: Doing a ''G28'' resets the autolevel values! I am still trying to figure out how to get Octoprint to not reset my auto level values before printing. | NOTICE: Doing a ''G28'' resets the autolevel values! I am still trying to figure out how to get Octoprint to not reset my auto level values before printing. | ||