Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
anycubic_kossel_plus [2017/05/14 15:48] sschueller created |
anycubic_kossel_plus [2017/06/23 12:31] (current) sschueller |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Anycubic Kossel Plus ====== | ====== Anycubic Kossel Plus ====== | ||
| - | ===== BL / 3D Touch Setup ===== | + | * [[BL Touch]] |
| - | ==== Hardware ==== | + | * [[Inductive Probe]] |
| - | - Print bracket such as: http://www.thingiverse.com/thing:2251115 | + | |
| - | - Connect White/Black wire to z-min-endstop (S = (signal - white), - = (minus - black)). Orientation doesn't matter | + | |
| - | - Connect Brown/Red/Orange wire to servo 0 port (S = Orange, + = Red, - = Brown) NOTE: on the Tri Gorila Board + and - are reversed. | + | |
| - | {{::20170513_152037.jpg?direct&300|}}{{::20170513_164053.jpg?direct&300|}} | + | |
| - | + | ||
| - | ==== Software (Marlin) ==== | + | |
| - | + | ||
| - | + | ||